Desa B Manuel d'utilisateur télécharger pdf (Page 18)

18

104414

DESA INTERNATIONAL

UNVENTED NATURAL GAS LOG HEATER

CLEANING AND

MAINTENANCE

WARNING: Turn off heater

and let cool before cleaning.

CAUTION: You must keep

control areas, burners, and cir-

culating air passageways of

heater clean. Inspect these areas

of heater before each use. Have

heater inspected yearly by a quali-

fied service person. Heater may

need more frequent cleaning due

to excessive lint from carpeting,

pet hair, bedding material, etc.

LOGS

• If you remove logs for cleaning, refer to

Installing Logs, page 13, to properly re-

place logs.

• Replace log(s) if broken or chipped

(dime-sized or larger).

CLEANING BURNER

INJECTOR HOLDER AND

PILOT AIR INLET HOLE

The primary air inlet holes allow the proper

amount of air to mix with the gas. This

provides a clean burning flame. Keep these

holes clear of dust, dirt, and lint. Clean these

air inlet holes prior to each heating season.

Blocked air holes will create soot. We rec-

ommend that you clean the unit every 2,500

hours of operation or every three months.

We also recommend that you keep the burner

tube and pilot assembly clean and free of

dust and dirt. To clean these parts we recom-

mend using compressed air no greater than

30 PSI. Your local computer store, hard-

ware store, or home center may carry com-

pressed air in a can. You can use a vacuum

cleaner in the blow position. If using com-

pressed air in a can, please follow the direc-

tions on the can. If you don't follow direc-

tions on the can, you could damage the pilot

assembly.

1. Shut off the unit, including the pilot.

Allow the unit to cool for at least thirty

minutes.

2. Inspect burner, pilot, and primary air

inlet holes on injector holder for dust

and dirt (see Figure 28).

Figure 28 - Injector Holder On Outlet

Burner Tube

3. Blow air through the ports/slots and

holes in the burner.

4. Check the injector holder located at the

end of the burner tube again. Remove

any large particles of dust, dirt, lint, or

pet hairs with a soft cloth or vacuum

cleaner nozzle.

5. Blow air into the primary air holes on

the injector holder.

6. In case any large clumps of dust have

now been pushed into the burner repeat

steps 3 and 4.

Clean the pilot assembly also. A yellow tip

on the pilot flame indicates dust and dirt in

the pilot assembly. There is a small pilot air

inlet hole about two inches from where the

pilot flame comes out of the pilot assembly

(see Figure 29). With the unit off, lightly

blow air through the air inlet hole. You may

blow through a drinking straw if compressed

air is not available.

Burner

Tube

Injector Holder

Primary Air Inlet

Holes

Figure 29 - Pilot Inlet Air Hole

Pilot Assembly

Pilot Air Inlet

Hole

Ports/Slots

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Commentaires sur ces manuels

Pas de commentaire