Desa Wall Mantel and Base with Trim W32WP Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Four Desa Wall Mantel and Base with Trim W32WP. Desa Wall Mantel and Base with Trim W32WP User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Tools required:
#2 Phillips driver bit (3
1
/
2
" min. length)
Slotted screw driver
Pencil
Measuring tape
Drill driver
If any wood pieces are missing or damaged, contact the
dealer where you purchased this mantel for replacement.
If hardware is missing or damaged, contact DESA Heating
Products at 1-866-672-6040 for referral information. You can
also visit DESA Heating Products’ technical service web site
at www.desatech.com.
Note: Gather all mantel pieces together before assembling
mantel.
WARNING: Only use 1
1
/
4
" screws in pocket holes to
assemble mantel. Damage to mantel will result if other
screws are used for this purpose.
WARNING: Use only 1/2" or 3/4" screws with brack-
ets in hardware pack 118983-01. Damage to mantel will
result if other screws are used for this purpose.
W32WP
Wall Mantel and Base with Trim
ASSEMBLY AND INSTALLATION INSTRUCTIONS
IMPORTANT: Read entire instruction sheet before
assembling or installing mantel kit.
This mantel is only approved for use with any DESA
Heating Products 32" replace system and Dimplex
Electric Fireplaces. Do not use mantel with any other
product.
This mantel kit contains the following:
Mantel pieces (unassembled)
• Dimplexelectricreplacekit(unassembled)119994-02
• Hardwarepackage 117197-01
• Brackethardwarekit 118983-01
Thehardwarepackage117197-01containsthefollowing:
32 - 1
1
4" Screws
2 - 3" Screws
For Dimplex Electric Fireplace Only use the following:
14 - 1
1
/
4
" Screws
2 - Short wood blocks
1 - Long wood block
1 - Dimplex header
Thehardwarekit118983-01containsthefollowing:
13 - Brackets
2 - Flat brackets
36 - 1/2" or 3/4" Screws
www.desatech.com
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - 4" Screws

Tools required:• #2 Phillips driver bit (3 1/2" min. length)• Slotted screw driver• Pencil• Measuring tape• Drill driverIf any wood piec

Page 2 - ELECTRIC FIREPLACE ONLY

www.desatech.com119939-01A2ASSEMBLING MANTELIMPORTANT: More than one person is required to lift assembled mantel. Lift mantel by leg assemblies. Lifti

Page 3 - ATTACHING TOP OF MANTEL

www.desatech.com 119939-01A3ATTACHING TOP OF MANTEL1. Place top onto mantel (see Figure 7). The rear of legs shouldbeushwithbackofman

Page 4 - INSTALLING FIREPLACE

2701 Industrial DriveP.O.Box90004BowlingGreen,KY42102-9004Technical Service and Parts: 1-866-672-6040OFF PILOT ON HI LO

Page 5 - 4"

Herramientas necesarias:• Punta del N° 2 para destornillador Phillips (8.9 cm [3 1/2"] de longitud mínima)• Destornillador de puna plana• Láp

Page 6 - ELÉCTRICAS DIMPLEX ÚNICAMENTE

www.desatech.com119939-01A2ENSAMBLE DE LA REPISA PARA CHIMENEAIMPORTANTE: se requiere de más de una persona para levantar la repisa para chimenea ensa

Page 7 - REPISA PARA CHIMENEA

www.desatech.com 119939-01A3Figura 7 - Colocación de la parte superior de la repisa sobre el ensamble de la repisa para chimeneaParte superior de la r

Page 8 - INSTALACIÓN DE LA CHIMENEA

2701 Industrial DriveP.O. Box 90004Bowling Green, KY 42102-9004, EE.UU.Servicio técnico y piezas: 1-866-672-6040OFF PILOT ON HI

Commentaires sur ces manuels

Pas de commentaire