Desa T Manuel d'utilisateur télécharger pdf (Page 20)

107070-01F

For more information, visit www.desatech.com

C. Use only your hand to push in or turn the gas control knob.

Never use tools. If the knob will not push in or turn by

hand, don’t try to repair it, call a qualified service techni-

cian or gas supplier. Force or attempted repair may result

in a fire or explosion.

D. Do not use this appliance if any part has been under water.

Immediately call a qualified service technician to inspect

the appliance and to replace any part of the control system

and any gas control which has been under water.

1. STOP! Read the safety information, starting in column 2,

page 19.

2. Make sure equipment shutoff valve is fully open.

3. Set selector switch in the OFF position.

WARNING: Burners will come on automatically

within one minute when the selector switch is in the

ON position after the pilot is lit.

LIGHTING

INSTRUCTIONS

WARNING

• If fireplace has glass doors, never operate this

heater with glass doors closed. If you operate

heater with doors closed, heat buildup inside fire-

place will cause glass to burst. Make sure fireplace

screen is closed before running heater.

• You must operate this heater with a fireplace screen

in place. Make sure fireplace screen is closed

before running heater.

NOTICE: During initial operation of new heater, burn-

ing logs will give off a paper-burning smell. Orange

flame will also be present. Open damper or window to

vent smell. This will only last a few hours.

Note:

Home owners generally prefer to operate their heater

with the chimney damper closed. This will put all the heat into

the room. However, there may be times you will desire the full

flames of the HI heat setting but will find the heat output

excessive. You can open the chimney damper (if you have one)

fully or partially to release some of the heat.

WARNING: Damper handle will be hot if heater

has been running.

Figure 30 - Control Knob and Ignitor Button Location (Shown as

Supplied, No Control Options)

OPERATING HEATER

Continued

Flame Adjustment Knob

AUTO

OFF

Control Knob

Ignitor Button

Selector Switch in OFF Position

OPERATING HEATER (REMOTE-READY MODELS)

For Your Safety Read Before Lighting (Cont.)

Lighting Instructions

4. Press in and turn control knob clockwise to the

OFF position (see Figure 30).

5. Wait five (5) minutes to clear out any gas. Then smell for

gas, including near the floor. If you smell gas, STOP! Fol-

low “B” in the safety information, starting in column 2,

page 19. If you don’t smell gas, go to the next step.

6. Press in and turn control knob counterclockwise

to the PILOT position. Press in control knob for five (5)

seconds (see Figure 30).

Note:

You may be running this heater for the first time

after hooking up to gas supply. If so, the control knob may

need to be pressed in for 30 seconds or more. This will al-

low air to bleed from the gas system.

7. With control knob pressed in, press and release ignitor

button. This will light pilot. The pilot is attached to the front

burner. If needed, keep pressing ignitor button until pilot

lights.

Note:

If pilot does not stay lit, contact a qualified service

person or gas supplier for repairs. Until repairs are made,

light pilot with match. To light pilot with match, see Manual

Lighting Procedure, page 21.

8. Keep control knob pressed in for 30 seconds after lighting

pilot. After 30 seconds, release control knob.

• If control knob does not pop out when released, contact

a qualified service person or gas supplier for repairs.

Note:

If pilot goes out, repeat steps 4 through 8, page 19.

9. Slightly push in and turn control knob counterclockwise

to the ON position.

10. Wait one minute and switch selector switch to the ON posi-

tion to light burners.

Note:

AUTO is only functional when

using GWMT1 or GWMS2 optional accessories.

11. Set flame adjustment knob to any level between HI and LO.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Desa T Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers Desa T