Desa HRC101 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Foyers Desa HRC101. Desa HRC101 User's Manual [en] Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Save for future reference.
For more information, visit www.desatech.com
WIRELESS HAND-HELD REMOTE CONTROL MODELS HRC100,
HRC101, HRC200 AND HRC201 OPERATING INSTRUCTIONS
For Use With DESA Heating Products Remote Ready Log Sets
and Fireplace Systems
INSTALLING REMOTE RECEIVER
1. Disconnect switch wires from the control valve.
Some units will have an ON/OFF switch with
switch plate that is connected to the control
valve. Other units will have a jumper wire that
will need to be removed from the control valve
(see Figure 1).
2. Remove screws and switch plate as shown in
Figure 1. Discard after removing.
3. Install remote receiver unit onto gas log heater
base using clips (2) and insulating washers
provided.
4. Pushclipsrmlyintoplace(seeFigure2).
5. Connect wires as shown in Figure 3.
Note: On yellow ame models,reuseprovided
phillips head screws and reinstall heat shield over
receiving unit.
INSTALLING WIRELESS REMOTE
CONTROL ACCESSORY
Two 9-volt alkaline batteries (not included) are
required to operate this wireless hand held remote
controlset.Onebatterymustbeinstalledinthe
receiver and one in the hand-held remote control
unit. Note:Onlyusealkalinebatteries.
Installing 9-Volt Battery (Not Included) in
Receiver
1. Locatethebatteryclipmountedontheback
of the receiver.
2. Slidea9-voltbatterythroughtheclip.
3. Attachtheterminalwirestothebattery.
Figure 1 - Disconnecting Wires from
Control Valve
Front
Back
Wires to
Control Valve
Screw
Jumper Wire
Control Valve
Figure 2 - Installing Remote Receiver
Front
Back
Insulating
Washers
Remote
Receiver
Mounting
Clips
Figure 3 - Connecting Wires
Valve
Red Wire
From
Receiver
White
Wire From
Receiver
Battery Clip
ON/OFF Switch with
Switch Plate
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - CONTROL ACCESSORY

Save for future reference.For more information, visit www.desatech.comWIRELESS HAND-HELD REMOTE CONTROL MODELS HRC100, HRC101, HRC200 AND HRC201 OPERA

Page 2 - REMOTE OPERATION

www.desatech.com116710-01C29-Volt BatteryBattery HousingInstalling 9-Volt Battery (Not Included) in Hand-Held Remote Control Unit1. Remove battery

Page 3 - 116710-01C 3

www.desatech.com116710-01C 3THERMOSTAT SERIES (MODELS HRC200 AND HRC201)The hand-held remote can be operated using either the manual mode (MANU)

Page 4 - DOCKING STATION

2701 Industrial DriveP.O. Box 90004Bowling Green, KY 42102-9004www.desatech.comDOCKING STATIONThe wall docking station offers a convenient loca-tiont

Page 5 - INALÁMBRICO

Conserve este instructivo para referencia futura.Para obtener más información, visite www.desatech.comINSTRUCCIONES DE OPERACIÓN PARA LOS MODELOS HRC1

Page 6 - OPERACIÓN REMOTA

www.desatech.com116710-01C6OFF PILOT LO IH REMOTEOFFONON Batería de 9 voltiosCompartimento de bateríaInstalación de la batería de 9

Page 7 - 116710-01C 7

www.desatech.com116710-01C 7SERIE CON TERMOSTATO (MODELOS HRC200 Y HRC201)El control remoto puede utilizarse ya sea enmodo manual (MANU) o en

Page 8 - BASE PARA EL CONTROL REMOTO

2701 Industrial DriveP.O. Box 90004Bowling Green, KY 42102-9004, EE.UU.www.desatech.com116710-01Rev. C08/06116710 01BASE PARA EL CONTROL REMOTOLa bas

Commentaires sur ces manuels

Pas de commentaire