Desa B Manuel d'utilisateur télécharger pdf (Page 20)

104415

For more information, visit www.desatech.com

Shutting Off Heater

1. Turn control knob clockwise to the OFF position.

2a. Set selector switch in the OFF position.

2b. If Using Optional Hand-Held Remote: Set selector switch

in the OFF position to prevent draining battery.

Shutting Off Burners Only (pilot stays lit)

You may shut off the burners and keep the pilot lit by doing one

of the following:

1. Turn control knob clockwise to the PILOT position.

2. Use remote control manual OFF button.

3. Set selector switch in the OFF position.

CAUTION: Do not try to adjust heating levels by

using the equipment shutoff valve.

8. Keep control knob pressed in for 30 seconds after lighting

pilot. After 30 seconds, release control knob.

• If control knob does not pop out when released, contact

a qualified service person or gas supplier for repairs.

Note:

If pilot goes out, repeat steps 4 through 8, page 19.

9. Slightly push in and turn control knob counterclockwise

to the ON position.

10. Wait one minute and switch selector switch to the ON posi-

tion to light burners.

Note:

AUTO is only functional when

using GWMT1 or GWMS2 optional accessories.

11. Set flame adjustment knob to any level between HI and LO.

WARNING: Make sure the selector switch is in the

OFF position when you are away from home for long

periods of time. Heater will come on automatically

with selector switch in the ON position.

OPERATING HEATER

Continued

MANUAL LIGHTING PROCEDURE

1. Follow steps 1 through 6 under Lighting Instructions, page 19.

2. Depress control knob and light pilot with match.

3. Keep control knob pressed in for 30 seconds after lighting

pilot. After 30 seconds, release control knob. Now follow

steps 9 through 11, Lighting Instructions, column 1.

Figure 30 - Pilot (Propane/LP)

Ignitor

Electrode

Pilot

Burner

Figure 31 - Pilot (Natural)

Ignitor

Electrode

Pilot

Burner

TO TURN OFF GAS TO APPLIANCE

Note:

All remote control accessories must be purchased sepa-

rately (see Accessories, page 36). Follow instructions included

with the remote control.

Thermostat Control Operation

(Optional GHRCTA Series Only) The thermostat control set-

ting on the remote control unit can be set to any comfort level

between WARMER and COOLER. The burners will turn on

and off automatically to maintain the comfort level you select.

The ideal comfort setting will vary by household depending

upon the amount of space to be heated, the output of the central

heating system, etc.

For wall thermostat operation, follow instruction supplied with

thermostat accessory GWMT1. For wall switch operation fol-

low instructions supplied with GWMS2.

OPTIONAL REMOTE OPERATION

NOTICE: You must light the pilot before using the remote

control unit. See

Lighting Instructions

on page 19.

1. After lighting, let pilot flame burn for about one minute.

Turn control knob to ON position. Adjust flame adjust-

ment knob anywhere between HI and LO. Slide the selec-

tor switch to the REMOTE position.

Note:

The burners

may light if hand-held remote ON button was on when se-

lector switch was last turned off. You can now turn the burn-

ers on and off with the hand-held remote control unit.

IMPORTANT:

Do not leave the selector switch in the RE-

MOTE or ON position when the pilot is not lit. This will

drain the battery.

IMPORTANT:

Be sure to press the ON/OFF buttons on the

hand-held remote control unit for up to 3 seconds to assure

proper operation.

OPERATING HEATER (REMOTE-READY MODELS)

Lighting Instructions (Cont.)

To Turn Gas Off To Appliance

Manual Lighting Procedure

Optional Remote Operation

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Desa B Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers Desa B